| 1. | Write down the channels for the radio station presets. Make sure the ignition switch is OFF. |
| 2. | Disconnect the negative battery cable, then disconnect the positive cable, and wait at least 3 minutes. |
| 3. | Remove the screws (A) for the alternator and battery cable terminals from the under-hood fuse/relay box.
|
| 4. | Disconnect the connectors from the under-hood fuse/relay box. |
| 5. | Carefully remove the relays by prying under the base of the relay. NOTE: Do not use pliers; pliers will damage the relays, which could cause the engine to stall or not start. |
| 1. | Install the relays and connect the connectors to the under-hood fuse/relay box, then install the under-hood fuse/relay box in the reverse order of removal. |
| 2. | Install the removed parts in the reverse order of removal. |
| 3. | Connect both the positive cable and negative cables to the battery. |
| 4. | Do the idle learn procedure. |
| 5. | Enter the customer's radio station presets. |
| 6. | Reset the clock. |
| 7. | Confirm that all systems work properly. |