1. | Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
|
2. | Turn the ignition switch ON (II). |
3. | Make sure the HDS communicates within the ECM. If it doesn't, go to the DLC circuit troubleshooting. |
4. | Turn the ignition switch OFF, and wait 1 minute. |
5. | Remove the center console. |
6. | Remove the passenger's kick panel. |
7. | Disconnect the ECM connectors (A).
|
8. | Remove the bracket (B), then remove the ECM (C). |
9. | Install the ECM in the reverse order of removal. |
10. | Turn the ignition switch ON (II). NOTE: DTC P0630 ‘‘VIN Not Programmed or Mismatch'' will be stored because VIN has not been programmed into the ECM. Ignore it, and continue this procedure. |
11. | Input the VIN to the ECM with the HDS. |
12. | Select the IMMOBILIZER SYSTEM with the HDS. |
13. | Rewrite the immobilizer code with the ECM replacement procedure in the HDS; it allows you to start the engine. |
14. | Reset the ECM with the HDS. |