| 1. | Disconnect the negative cable from the battery first, then disconnect the positive cable. |
| 2. | Remove the drive belt. |
| 3. | Remove the air intake duct.
|
| 4. | Disconnect the alternator connector (A) and BLK wire (B) from the alternator.
 |
| 5. | Remove the harness clamps (C) from the alternator. |
| 6. | Remove the alternator.
 |
| 1. | Install the alternator.
 |
| 2. | Connect the alternator connector (A) and BLK wire (B) to the alternator.
 8 N·m (0.8 kgf·m, 6 lbf·ft) |
| 3. | Install the harness clamps (C) to the alternator. |
| 4. | Install the air intake duct.
 9.8 N·m (1.0 kgf·m, 7.2 lbf·ft) |
| 5. | Install the drive belt. |
| 6. | Adjust the belt tension. |
| 7. | Connect the positive cable to the battery first, then the negative cable. |
| 8. | Set the clock. |
| 9. | Do the power window control unit reset procedure. |